


HAVING ISSUES WITH YOUR WALK-IN COOLER?
CALL US NOW!
Our Customers LOVE US
SCHEDULE YOUR APPOINTMENT NOW
Feel Free to Call Us at Any Time!! (206) 895-9715
Watch for early warning signals to maintain your walk-in cooler. Fixing problems quickly helps prevent system breakdowns and lower repair costs.
If a cooler fails to maintain the temp stable, products could go bad and there might be safety issues. This problem could be caused by issues with faulty sensors, an unbalance of cooler, or a lack of flow in the walk in cooler. Timely repair stabilizes and protects stored commodities.
Frost can reduce airflow and cooling efficiency. Defrost processes can be messed up or drainage problems can let water in. Regular servicing stops ice from forming around and gets the cooler machine running again.
Warm air might enter the cooler through worn or misaligned door seals, making the system work harder. This strains internal components and uses more energy. Replace damaged gaskets to preserve insulation and efficiency.
A compressor cycles refrigerant through out the cooler. If it fails due to electrical component issues, over heating or wear down, cooling performance declines. Professional repair keeps the cooler running and prevents breakdown.
Fans that are blocked or have junk in them which do not let air circulate properly, which makes cooling inconsistent and wastes energy. To maintain performance up and pressure on the system down, these parts need to be cleaned and cared for.
SCHEDULE YOUR APPOINTMENT NOW
SCHEDULE YOUR APPOINTMENT NOW
Easy Schedule Your Appointment Online
For your diagnostic & repair service please complete the Contact Form:
Don't hesitate to give us a call! (206) 895-9715
CALL US NOW!
Equipment down right now in Kenmore? Emergency commercial refrigeration repair is available same-day or next-day across the metro. Same-day slots fill fastest, so call as early as you can.
Yes. Kenmore is inside our regular King County coverage and we dispatch there from our Shoreline location. Kenmore calls are scheduled the same way as any other stop in the metro, on a same-day or next-day basis.
We handle the full range of walk-in cooler work: diagnosis, component replacement, and preventative service. There is no manufacturer we will not diagnose, and parts availability is generally good even on discontinued models.
Most Kenmore calls are handled same-day or next-day. We do not run an overnight crew and will not claim otherwise, but commercial breakdowns are prioritized within our working schedule.
The diagnostic fee is $99.99. Approve the estimate and it is waived, so in practice most customers never pay it separately.
Our coverage spans the full manufacturer range. Technicians are certified and train continuously, which matters most on newer equipment where diagnostics run through the controller.
Catching these early is the difference between a routine service call and a compressor bill. Most of what follows is preventable with a maintenance interval that actually gets kept.
A box that will not hold its setpoint is usually airflow or refrigerant, not the controller. We check condenser cleanliness, evaporator fan operation and door seal integrity before touching a gauge set, because a fouled coil imitates a refrigerant fault almost exactly.
Frost on the evaporator or ceiling panel almost always traces to a defrost fault: a failed termination thermostat, a heater gone open, or a timer that is not initiating. On older boxes it is just as often a door left ajar during deliveries.
Gaskets compress and split with volume, and hinge cartridges sag. Warm humid air leaking past a bad seal runs the compressor continuously, drives up power draw, and eventually turns a cheap gasket job into a compressor replacement.
Short-cycling, hard starts, or a unit tripping on overload usually points at start components or a compressor drawing high amps with age. This is where we give you an honest repair-versus-replace number rather than defaulting to replacement.
Overpacked shelving, blocked evaporator return, or product stacked against the coil will starve the box of circulation. It presents as uneven cooling, warm spots near the door, and product freezing directly under the evaporator.